Janet
- Total activity 455
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 226
Articles
Recent activity by Janet-
What is the tolerance level for the tank pressure gauge on the D55168 and D55146 compressors?
The tank pressure gauge on the D55168 and D55146 is +/-12 psi. The safety valve is set for 225 and will prevent the tank from being pressurized too high.
-
How do I replace the belt on the D55168/D55146/D55167?
When replacing a belt on an EHP compressor (ie. D55168), proper tension is critical. If there is not enough tension, the belt will spin and wear the rubber surface off. If there is too much tension...
-
How long does it take for the D55168 to go from 0 - 200 PSI?
It will take approximately 5 minutes to go from 0-200 psi.
-
What is the difference between the D55168 offered in the US and the D55168CA offered in Canada?
Canada requires a lower amp draw (15 amp) than the US (16.5 amp), so the motor cannot be run as hard, and thus the air delivery is a bit lower.
-
Can the D55168 put out 200 PSI of regulated air?
No, the tank pressure goes up to 200 PSI, but the max regulated amount is about 150 PSI.
-
What are the CFM and PSI ratings for the D55168-CA compressor sold in Canada?
Answer See the chart below. CFM PSI7.2 106.7 256.2 405.6 604.8 90
-
What is the CFM rating of the D55168 Heavy Duty 15 Gallon electric wheeled portable compressor?
Answer The CFM ratings of D55168 Types 1, 2, and 3 are as follows: CFM PSI 8.1 10 7.5 25 7 40 6.3 60 5.4 90 The CFM ratings for D55168...
-
How many hours of use can you expect from the major wear components on the D55168 compressor?
Answer The D55168 is rated for a life of approximately 500 hours. That time will shorten in dry or abrasive environments and lengthen in a normal workshop environment. The motor brushes are the lif...
-
What is the horsepower rating of the D55168?
Answer The D55168 is rated at 1.8 HP continuous.
-
What is the sleeve on the D55168 pump made of?
Answer The sleeve on the pump of this unit is cast iron.