Janet
- Total activity 455
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 226
Articles
Recent activity by Janet-
What mounting options are available for the DEWALT DCE511 jobsite fan besides freestanding?
The DEWALT DCE511 jobsite fan has built in integrated dual tripod mounts (¼” #20 and ⅝” #16), extendable metal hang hooks and keyhole screw mounts are all options for mounting.
-
Does the DEWALT DCE511 jobsite fan have a brushed or brushless motor?
The motor on the DEWALT DCE511 jobsite fan is brushed.
-
Can the DG6000 and the DG7000 run both 120v and the 240v at the same time?
You can use the dual voltage units on both voltages at the same time. It splits the available amps and watts to both voltages. VOLTAGE SELECTOR SWITCH This switch allows the generator to operate in...
-
What wattage generator would you recommend using with the DEWALT Hand Carry Air Compressors?
We recommend using no less than a 5000-watt generator with any of our hand carry electric compressors.
-
Can a remote starter be used on the DG6000E or DG7000E Generators?
Yes, as these units have a 12v starting system like that of an automobile, there is no reason that a remote starter could not be attached to either the DG6000E or DG7000E generators. We do not...
-
Can I use a more Eco-friendly gas, like E85, in a DEWALT Engine?
DEWALT recommends using gasoline with up to 5% alcohol. Using gasoline with a higher alcohol mixture can damage the engine and the carburetor.
-
Why is my DEWALT engine stalling out or hard to start?
If your DEWALT engine is stalling and then is hard to restart, try loosening the gas cap and try starting the unit. If the unit restarts and does not shut down after about 5 minutes the gas cap is ...
-
What does "neutral bonded to the frame" mean regarding our DEWALT generators?
Neutral bonded to frame means that the metal of the generator frame is electrically connected to the generator windings. It is necessary for proper ground fault outlet operation.
-
What should be done if the output voltage on my generator is up to 30 volts lower than the required 120/230 volt?
You will need to have the RPMs adjusted. The unit should be taken into a service center for adjustment. To locate the nearest service center click here.
-
Is there a kit to convert the DG7000 generator to electric (battery) start?
There is no kit to convert the DG7000 to electric (battery) start. If you want the battery start model you would need to purchase the DG7000E .