Janet
- Total activity 455
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 226
Articles
Recent activity by Janet-
Is the tank on the D55168 ASME rated?
Answer Yes, the tank on the D55168 is ASME rated. On the back side of the unit there is a metal plate approximately 2" X 4", spot welded to the tank, usually under the Serial Number label and above...
-
What compressors no longer require the break-in procedure?
Answer See the chart below. DEWALT Sears Porter Porter Cable D55141 919-15216 C2002 D55141BNS 919-15316 ...
-
D55168-What are the cylinders made out of in the compressor?
Answer The cylinders are made of a plated steel material.
-
What are the black particles (dust) that is coming off the D55168 Compressor?
Answer The black particulate is dust from the belt. This is normal during the first few hours of running the compressor. The amount of dust should decrease over time.
-
What are the cfm ratings for D55167 compressor?
Answer 6.4 cfm @ 40 psi 5.0 cfm @ 60 psi 4.8 cfm @ 90 psi
-
What type of compressor does the D55167 have?
The D55167 has a piston type compressor.
-
What is the amp rating on D55167?
Answer The amp rating is 15.
-
Does my air compressor require a break in period?
Many compressors manufactured today do not require a break in period. Be sure to read your manual thoroughly before operating it, and follow any suggested start up procedures there. If the manual d...
-
Why won't my compressor power on?
If your compressor does not power on: check power supply is working check extension cord is correct gauge Motor overload switch tripped loose electrical connections defective motor blown fuse...
-
My compressor continues to run and build pressure past its advertised cut off pressure until the safety valve engages. How can I fix it?
The pressure switch controls what pressure the compressor cuts on and off. This setting can not be altered. If your air compressor does not stop building air the pressure switch must be replaced by...