Janet
- Total activity 455
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 226
Articles
Recent activity by Janet-
Why doesn't my tool have a Double Insulated symbol on the label?
If your tool has three prongs on the plug it does not require the square within the square symbol which would indicate it is double insulated. A three pronged plug indicates that your tool would be...
-
When should brushes be replaced?
As a guide, brushes should be replaced when they have become 50% worn. While the brushes will still function at 50%, the brush tension is reduced and can cause higher current draw and over-heating ...
-
Are the tools with two prong cords OSHA approved?
Our 2-wire double insulated and 3-wire grounded tools are in compliance with OSHA requirements. The OSHA specification dealing with grounded or double insulated tools is in Standard 1910.304. Other...
-
Can DEWALT cordless tools be used around high voltage power lines?
We only test to ESD standards…electrical spark discharge…which is NOT an electrical field generated by a power line.What this means is that due to the electromagnetic field generated around high vo...
-
How do I put the cordless compact drills or cordless impact drivers and wrenches back in the kit box?
See the attached picture for the information you are requesting. https://gts-na--c.na105.content.force.com/servlet/fileField?id=0BEC0000000Gq0B
-
What are the sizes of the DEWALT Cordless Bandsaw Blades?
The following blades are 32-7/8" L x 1/2" W x .020" Thick: DW3982C 14 TPIDW3983C 18 TPIDW3984C 24 TPIDW3986C 14/18 TPI
-
What is the thickness and width of the DW6658 blades?
Answer The thickness of the blade is 1.2mm +/-.02 and the width is 5.35mm +/-.1.
-
Why are hand clamp faces not parallel when not under load?
The jaws used on our clamps are plastic and are designed to flex as the load is increased. This is the mechanism by which clamp pressure is held. As these flex, the angle between the faces will inc...
-
How do you convert the DWHT83197 clamp set into a spreader?
The four larger clamps do not convert to a spreader.The two small clamps convert via the Phillips head screw that you remove and then attach to the other end of the bar.
-
What is the throat depth of the DEWALT DWHT83149 Trigger Clamps?
The throat depth of the DWHT83149 trigger clamps is 2 7/16 inch