Janet
- Total activity 455
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 226
Articles
Recent activity by Janet-
Why is my DEWALT engine stalling out or hard to start?
If your DEWALT engine is stalling and then is hard to restart, try loosening the gas cap and try starting the unit. If the unit restarts and does not shut down after about 5 minutes the gas cap is ...
-
What does "neutral bonded to the frame" mean regarding our DEWALT generators?
Neutral bonded to frame means that the metal of the generator frame is electrically connected to the generator windings. It is necessary for proper ground fault outlet operation.
-
What should be done if the output voltage on my generator is up to 30 volts lower than the required 120/230 volt?
You will need to have the RPMs adjusted. The unit should be taken into a service center for adjustment. To locate the nearest service center click here.
-
Is there a kit to convert the DG7000 generator to electric (battery) start?
There is no kit to convert the DG7000 to electric (battery) start. If you want the battery start model you would need to purchase the DG7000E .
-
What is the required cranking amps for the DG7000B generator?
The generator requires approximately 70A to begin cranking the engine. The current will quickly drop off to approximately 20A.
-
When I start my machine, smoke constantly comes from the engine muffler.
Most commonly this is due to the engine being over filled with oil. If the oil level is correct then it is possible that the intake air filter could have oil on it. In that case the air filter will...
-
Do DEWALT generators have a voltage regulator?
No, DEWALT generators offer "Voltage Compensation" control scheme on our generators because we have brushless alternators. Automatic Voltage Regulators (AVR) are used on brushed type alternators, w...
-
How can I get a copy of the manual for the Honda motor on my DEWALT Generator, Pressure Washer or Compressor?
The manuals for the Honda Motor on the DEWALT Generators, Pressure Washers and Compressors are attached, see the chart listed below for information on the specific manual required for your equipmen...
-
I need the bolts, nuts and washers for the battery cables on my generator, what can I order?
You can use service part number 5140021-99 in order to get the bolts, nuts and washers that you are looking for. For information on how to order this .
-
Why did my generator shut off when the engine went from full speed to idle?
The oil level on your generator may be low. Our DEWALT generators have a low oil shut off feature. Make sure the generator is sitting on a level surface when running; if your generator is not sitti...